What should be noted when using a pneumatic winch?
Release time:
2021-01-18
When using a pneumatic winch, attention should be paid to starting the main motor. The motor rotates through a high-speed coupling to transmit power to the high-speed shaft of the reducer. After the pneumatic winch is decelerated through a two-stage gear transmission device, the load-bearing shaft of the reducer is transmitted through the coupling to the spindle device. If the direction of the motor is constantly changed, the drum may wind or loosen, and the container may move up and down periodically in the shaft.
UsePneumatic winchWhen using, pay attention to starting the main motor. The motor rotates through a high-speed coupling to transmit power to the high-speed shaft of the reducer. After the pneumatic winch is decelerated through a two-stage gear transmission device, the force-bearing shaft of the reducer is transmitted through the coupling to the spindle device. If the direction of the motor is constantly changed, the drum may wind or loosen, and the container may move up and down periodically in the shaft.
Pneumatic winchThe gasket of the flange part of the chassis is damaged or leaking. Replace with a new gasket, use twisted sealant, and then re-tighten the flange bolts. The height difference of the input material is too large, requiring a change in the material input method, and a buffering device for inputting materials should be added.
Insufficient capacity of the mechanical equipment at the front of the propeller leads to low material input, preventing the propeller from reaching its design capacity.Pneumatic winchIt is necessary to find ways to improve the production capacity of the front machine equipment or measurement errors, check the instruments and the ratio of materials, and modify the calculation method from scratch. Improve the capacity of the rear mechanical equipment to block the discharge chute and enhance the production capacity of the rear mechanical equipment.
Pneumatic winchThe inspection work before operation is as follows: Check whether the bolts of each hinge part are loose, whether the pin shafts are loose; check whether the oil quality of each lubrication part is qualified, whether the oil quantity is sufficient, and whether there is oil leakage; check the working brake of the braking system, check whether the safety door is sensitive and reliable, whether the gap, stroke, and wear meet the requirements; check whether the actions of various safety protection devices are accurate and reliable; check whether various instruments and light signals are clear and accurate; check whether the temperature of the main motor meets the requirements, etc. The inspection must be thorough.
RELATED INFORMATION
